Wiper Motor - Windshield

WIPER MOTOR - WINDSHIELD

Exploded View

Front Wiper System:

Rear Wiper System:

Washer System:

Removal and Installation
1. Remove the mounting arm and pivot shaft.

2. NOTE: Mark the position of the windshield wiper motor crank before it is disconnected.

Disconnect the windshield wiper motor crank.
- Remove the bolt.
- To install, tighten to 18 Nm (13 lb-ft).







3. Remove the bolts and the windshield wiper motor.
- To install, tighten to 15 Nm (11 lb-ft).







4. NOTE: The windshield wiper motor crank must be set to the same location for the windshield wiper mounting arm and pivot shaft to be installed properly. Refer to Component test.

To install reverse the removal procedure.