Power Running Board (PRB) Bracket

POWER RUNNING BOARD (PRB) BRACKET







Removal and Installation

NOTE: The power running board (PRB) bracket assemblies cannot be serviced individually. The complete bracket assembly and linkage must be serviced as a unit.

Explorer only
1. Remove the PRB gap hider.

Mountaineer only
2. With the vehicle in NEUTRAL, position it on a hoist.

3. NOTE: If the PRB cannot be extracted, extend the running board by hand.

Extend the retractable running board.

All vehicles
4. Remove the PRB step.
5. Remove the PRB motor assembly.

6. NOTE: An assistant is required to hold the PRB bracket assembly before removing the lower bolts.

Remove the PRB front bracket lower 2 nuts and bolt.
- To install, tighten to 23 Nm (17 lb-ft).







7. Remove the PRB rear bracket lower 2 nuts and bolt.
- To install, tighten to 23 Nm (17 lb-ft).







8. To install, reverse the removal procedure.