Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 2008 >> Explorer 4WD V8-4.6L >> Repair and Diagnosis >> Brakes and Traction Control >> Antilock Brakes / Traction Control Systems >> ABS Sensor Block >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la
If it fails: lemon-manuals.org.ua

Or, hide this message: temporarily or permanently

ABS Sensor Block: Service and Repair

Stability Control Sensor Cluster








Removal and Installation

NOTE: When installing a new stability control sensor cluster, the ABS module must be calibrated. Follow the scan tool directions for the calibration procedures.

1. Remove the pin-type retainer and the LH floor console finish panel.
2. Remove the 2 bolts, 2 nuts and the LH instrument panel brace.
^ To install, tighten to 9 Nm (80 lb-in).
3. Remove the 2 bolts and LH floor heater duct.
4. Disconnect the stability control sensor cluster electrical connector.
5. Remove the stability control sensor cluster electrical harness retainers and position aside.
6. Remove the 2 stability control sensor cluster bracket nuts and the stability control sensor cluster.
^ To install, tighten to 7 Nm (62 lb-in).
7. To install, reverse the removal procedure.
pro multis · About Operation CHARM