Electronic Brake Control Module: Service and Repair

Anti-Lock Brake System (ABS) Module





Removal and Installation

CAUTION: Electronic modules are sensitive to electrical charges. The anti-lock brake system (ABS) module can be damaged if exposed to these charges.

NOTE: When installing a new ABS module, it must be configured (using vehicle as-built data) and calibrated. Follow the scan tool directions for the calibration procedures. For module configuration, refer to Programmable Module Installation in Information Bus (Module Configuration).

1. Remove the hydraulic control unit (HCU).
2. Remove the 4 screws and the ABS module.
^ To install, tighten to 2 Nm (18 lb-in).

3. CAUTION: Make sure that the anti-lock brake system (ABS) module is properly seated to the hydraulic control unit (HCU) and that the torque of the ABS module screws is correct, or damage to the components can occur.

To install, reverse the removal procedure.