Leak Detection Valve: Service and Repair

EVAPORATIVE EMISSION CANISTER VENT SOLENOID

Evaporative Emission (EVAP) Canister Purge Valve:

EVAP Canister Assembly - Removal:

EVAP Canister Assembly - Disassembly:

Exploded View

Removal and Installation

WARNING:
- When working on or near the evaporative emission (EVAP) system, disconnect the battery ground cable from the battery. The EVAP system contains fuel vapor and condensed fuel vapor, so an electrical spark may cause a fire or explosion. Failure to follow this instruction may result in serious personal injury.
- Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.

1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.

3. NOTE: The evaporative emission (EVAP) canister assembly is located above the spare tire.

Remove the spare tire.

4. Disconnect the fuel vapor tube quick connect coupling.
5. Disconnect the fuel vapor hose.







6. Remove the 2 front EVAP canister assembly bracket bolts.
- To install, tighten to 13 Nm (10 lb-ft).







7. Remove the 2 outer rear EVAP canister assembly bracket bolts.
- To install, tighten to 20 Nm (15 lb-ft).







8. Remove the 2 inner rear EVAP canister assembly bracket bolts.
- To install, tighten to 13 Nm (10 lb-ft).







9. Lower the EVAP canister assembly down slightly to disconnect the EVAP canister vent solenoid electrical connector and remove the EVAP canister vent solenoid harness pushpin retainer.
10. Remove the EVAP canister assembly.
11. Remove the EVAP canister heat shield.
12. Disconnect the EVAP canister-to-EVAP filter assembly tube fuel vapor hose.
13. Remove the EVAP canister vent solenoid and EVAP filter assembly tube from the EVAP assembly.
14. Disconnect the EVAP canister vent solenoid-to-dust separator fuel vapor hose.
15. Separate the EVAP canister vent solenoid from the EVAP filter assembly tube.
16. To install, reverse the removal procedure.