Front

Wheel Speed Sensor - Front, Four Wheel Drive (4WD)

Wheel Speed Sensor - Front, Four Wheel Drive (4WD):

Removal and Installation
1. Remove the wheel and tire.

2. NOTE: The harness connector is located in the engine compartment secured to the fender apron.

Disconnect the wheel speed sensor electrical connector.
3. Disconnect the 2 wheel speed sensor harness retainers from the brake hose.
4. Remove the wheel speed sensor harness from the pushpin retainer.

5. CAUTION: Do not allow the brake caliper and anchor plate assembly to hang from the brake hose or damage to the hose can occur.

Remove the 2 brake caliper anchor plate bolts and position the brake caliper and anchor plate assembly aside.
^ Support the brake caliper anchor plate assembly using mechanic's wire.
^ To install, tighten to 112 Nm (83 lb-ft).

6. NOTE: Index-mark the brake disc and wheel hub flange before removing the brake disc. Remove the brake disc.

7. Remove the bolt and the wheel speed sensor.
^ To install, tighten to 8 Nm (71 lb-in).
8. To install, reverse the removal procedure.
^ Apply brakes several times to verify correct brake operation.