Starting System: Description and Operation

STARTING SYSTEM

The starting system consists of the following:
- Starter motor
- Starter solenoid
- Starter motor relay
- Starter drive
- Battery
- Digital transmission range (TR) sensor (automatic transmission)
- Clutch pedal position (CPP) switch (manual transmission)
- Ignition switch
- PCM
- One-touch integrated start (OTIS) diode (automatic transmission)

The function of the starting system is to crank the engine at a speed fast enough to permit the engine to start. When the starter solenoid is energized, a magnetic field is created in the starter solenoid windings. The iron plunger core is drawn into the starter solenoid coil, and a drive lever and pin connected to the starter drive engages the drive pinion gear to the flexplate/flywheel ring gear. When the plunger is pulled all the way in, the contact disc closes the circuit between the battery and the motor feed terminals. This sends current to the motor and the drive pinion gear cranks the flexplate/flywheel to start the engine. When current flows to the starter motor, the starter solenoid pull-in coil is bypassed, and the hold-in coil keeps the drive pinion gear engaged with the flexplate/flywheel.

Automatic transmissions have a digital TR sensor mounted on the transmission. The TR sensor prevents operation of the starter motor unless NEUTRAL or PARK is selected.

Manual transmission have a clutch pedal position (CPP) switch. The CCP switch prevents operation of the starter motor unless the clutch pedal is in the applied position which supplies a ground circuit to the PCM.

One-Touch Integrated Start (OTIS)
The vehicle is equipped with OTIS, a computer-assisted cranking system. This feature assists in starting the engine. If the ignition key is turned to the START position and released when the engine begins cranking, the engine may cranking for up to 10 seconds or until the vehicle starts.

Once the ignition is turned to the START position, the PCM reads starter motor request (SMR) from the ignition switch and gains control of the starter engagement. The customer is no longer in the after the initial crank request, the customer may release the key to the RUN/START position. The PCM will disengage the starter motor based on following events:
- The engine is started (rpm threshold)
- A set time has been exceeded
- The ignition key has been turned to the OFF position