Selector Lever - Column Shift

Selector Lever - Column Shift

Removal
1. Remove the steering wheel.
2. Remove the screw and the lower steering column shroud.





3. Remove the 2 screws and the upper steering column shroud.





4. Disconnect the overdrive cancel switch electrical connector.





5. Remove the retaining screw and remove the selector lever.





Installation
1. Position the selector lever in the steering column and install the screw.
^ Tighten to 20 Nm (15 lb-ft).





2. CAUTION: Route the overdrive cancel switch wire harness carefully to prevent damage to the wire harness.

Connect the overdrive cancel switch electrical connector.





3. Position the upper steering column shroud and install the 2 screws.





4. Position the lower steering column shroud and install the screw.





5. Install the steering wheel.