Turn Signal Switch: Service and Repair

Steering Column Multifunction Switch

Steering Column Multifunction Switch (Part 1):

Steering Column Multifunction Switch (Part 2):

Removal and Installation
1. Remove the steering column opening trim.
2. Remove the tilt lever dust boot.
3. Remove the screw and the tilt lever.
^ To install, tighten to 6 Nm (53 inch lbs.).
4. Remove the 3 screws and the upper and lower steering column shrouds.
5. Disconnect the multi-function switch electrical connector.
6. Remove the 2 screws and the multi-function switch.
^ To install, tighten to 1 Nm (9 inch lbs.).
7. To install, reverse the removal procedure.