Fuel Pump Module - Plastic Fuel Tank
FUEL PUMP MODULE - PLASTIC FUEL TANKMidship Fuel Tank - 114L (30 Gal) (Part 1):
Midship Fuel Tank - 114L (30 Gal) (Part 2):
Midship Fuel Tank - 148L (38 Gal) (Part 1):
Midship Fuel Tank - 148L (38 Gal) (Part 2):
Aft-of-Axle Fuel Tank - 151L (40 Gal) (Part 1):
Aft-of-Axle Fuel Tank - 151L (40 Gal) (Part 2):
Auxiliary Fuel Tank - 72L (19 Gal) (Part 1):
Auxiliary Fuel Tank - 72L (19 Gal) (Part 2):
Exploded View
Special Tool(s):
Special Tool(s)
Removal and Installation
NOTE: This procedure is for gasoline applications only.
1. NOTE: The fuel tank must be drained completely. Upon removal of the fuel pump (FP) module, the tank must be inspected for contamination.
Remove the fuel tank.
2. CAUTION: Clean the fuel tank of any dirt or foreign material before servicing the fuel pump (FP) module. In extreme dirt or dusty conditions it may be necessary to wash the fuel tank using a water hose. Before removing the FP module, make sure that there is no residual dirt or foreign material around the FP module flange. If dirt or foreign material enter the fuel tank, damage to the FP module or other fuel system components may occur.
Clean the area around the FP module mounting flange.
3. Using the special tool, remove the FP module lock ring.
4. CAUTION: The fuel pump (FP) module must be handled carefully to avoid damage to the float arm.
Completely remove the FP module from the fuel tank.
5. NOTE:
- Inspect the surfaces of the FP module flange and fuel tank O-ring seal contact surfaces. Do not polish or adjust the O-ring seal contact area of the fuel tank flange or the fuel tank. Install a new FP module or fuel tank if the O-ring seal contact area is bent, scratched or corroded or fuel leakage could occur.
- Make sure to install a new FP module O-ring seal and lock ring or fuel leakage could occur.
- Apply clean engine oil to the O-ring seal prior to installation.
Remove and discard the FP module O-ring seal.
6. To install, reverse the removal procedure.
- Make sure the alignment arrows on the FP module and the fuel tank meet before tightening the FP module lock ring.