Wheel Speed Sensor - Rear

Wheel Speed Sensor - Rear, All Wheel Drive (AWD)

Wheel Speed Sensor - Rear, All Wheel Drive (AWD):

Removal and Installation
1. Remove the rear seat bolster.
2. Disconnect the wheel speed sensor electrical connector.
3. With the vehicle in NEUTRAL, position it on a hoist.
4. Using a suitable tool, disconnect the grommet from the body.
5. Remove the wheel speed sensor harness nut and bolt.
^ To install, tighten to 23 Nm (17 lb-ft).
6. Remove the wheel speed sensor wire bolt and the wheel speed sensor.
^ To install, tighten to 23 Nm (17 lb-ft).
7. To install, reverse the removal procedure.