Intermediate Shaft Speed Sensor

Intermediate Shaft Speed Sensor

Material:

Intermediate Shaft Speed Sensor:

Removal
1. Disconnect the intermediate shaft speed sensor electrical connector.





2. Remove the bolt and the intermediate shaft speed sensor.
^ To install, tighten to 10 Nm (89 lb-in).
^ Check the sensor bore.
^ Check the O-ring seal for nicks or cuts and install a new O-ring if necessary.





Installation

1. NOTE: Apply a light coat of petroleum jelly to the O-ring seal before installation.

NOTE: Apply thread sealant to the bolt.

To install, reverse the removal procedure.