Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 2008 >> Mustang V6-4.0L >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Cylinder Block Assembly >> Engine Block Heater >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Engine Block Heater: Service and Repair

Block Heater








Removal and Installation
1. Drain the engine cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding.
2. Disconnect the block heater electrical connector and position aside.

3. NOTE: Do not loosen the block heater retaining screw more than necessary for removal.

Loosen the block heater retaining screw and remove the block heater.
^ To install, tighten to 2 Nm (18 lb-in).
4. To install, reverse the removal procedure.
^ Lubricate the block heater seal and the cylinder block hole with clean engine coolant to ease installation.
^ Make sure the block heater electrical connector is routed and secured away from rotating or hot components or damage to the cable can occur.
5. Fill and bleed the cooling system.
pro multis · About Operation CHARM