Seat Backrest - Front, 60 Percent

SEAT BACKREST - FRONT, 60 PERCENT

Exploded View

Seat Backrest, Front, 40 Percent:

Seat Backrest, Front, 60 Percent:

Seat Cushion, Front, 60 Percent (Part 1):

Seat Cushion, Front, 60 Percent (Part 2):

Seat Cushion, Driver, 40 Percent (Part 1):

Seat Cushion, Driver, 40 Percent (Part 2):

Seat Cushion, Front Passenger (Part 1):

Seat Cushion, Front Passenger (Part 2):

Seat Armrest, Front, 60 Percent:

Removal

All seats

WARNING: Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which increases the risk of serious personal injury or death.

NOTE:
- The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

1. Remove the 60 percent bench seat.
2. Remove the 60 percent bench armrest.
3. Remove the backrest recliner handle screw and the handle.
4. Remove the 2 side shield screws.
5. Pull out on the side and the rear of the side shield to detach the 2 clips (1 shown).







6. Remove the outboard recliner cable anchor and swivel and detach the recliner cable end.







7. Remove the outboard pin-type retainer and position the trim cover flap aside.







8. Remove the 2 outboard backrest-to-cushion bolts.
9. Remove the inboard seat backrest latch release cable anchor and swivel and detach the cable end.







10. Remove the front inboard backrest-to-cushion bolt.







SuperCab seat
11. Remove the inboard rear bolt cover.







All seats
12. Remove the inboard rear backrest-to-cushion bolt.







13. Remove the backrest assembly.

Installation

All seats
1. Install the backrest assembly.
2. Install the inboard rear backrest-to-cushion bolt.
- Tighten to 25 Nm (18 lb-ft).







SuperCab seat
3. Install the inboard rear bolt cover.







All seats
4. Install the inboard front backrest-to-cushion bolt.
- Tighten to 25 Nm (18 lb-ft).







5. Install the inboard seat backrest latch release cable end and swivel and install the cable anchor.







6. Install the 2 outboard backrest-to-cushion bolts.
- Tighten to 25 Nm (18 lb-ft).

7. Position the trim cover flap and install the outboard pin-type retainer.







8. Install the outboard seat backrest latch release cable end and swivel and install the cable anchor.







9. Position the side shield and install the 2 clips (1 shown).







10. Install the 2 side shield screws.
11. Install the backrest recliner handle and screw.
12. Install the 60 percent bench armrest.
13. Install the 60 percent bench seat.