60 Percent

SEAT CUSHION - FRONT, 60 PERCENT

Part 1:

Part 2:

Disassembly

WARNING: Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which increases the risk of serious personal injury or death.

NOTE:
- The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

1. Remove the affected seat.
2. Remove the armrest.
3. Remove the backrest assembly.
4. Remove the seat track.
5. Remove the 2 screws and seat track position sensor from the seat track.
6. Release the remaining trim cover J-clips.







7. NOTE: Note the routing of the seat back latch release cable through the seat cushion frame.

Release the pin-type retainer and remove the seat backrest latch release cable.







8. Remove the seat cushion frame from the seat cushion foam pad.
9. Remove the rows of hog rings and remove the seat cushion trim cover.







Assembly
1. Position the cushion trim cover to the foam pad and install the rows of hog rings.







2. Install the foam pad and trim cover to the seat cushion frame.
3. Route the seat backrest latch release cable through the cushion frame and install the pin-type retainer.







4. Fasten the trim cover J-clips.







5. Install the seat track position sensor and 2 screws to the seat track.
6. Install the seat track.
7. Install the backrest assembly.
8. Install the armrest.
9. Install the affected seat.