Seat - Front

SEAT - FRONT

60 Percent Seat:

40 Percent Seat:

Removal

WARNING:
- Always wear eye protection when servicing a vehicle. Failure to follow this instruction may result in serious personal injury.
- Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which increases the risk of serious personal injury or death.

NOTE:
- The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

All seats
1. Depower the SRS.
2. Position the seat fully forward.

60 percent seat
3. Remove the front center safety belt bolt.
- If equipped, release and pull the front center safety belt bolt cover upward on the front center safety belt.







All seats
4. Remove the 2 rear seat-to-floor bolts.
5. Position the seat fully rearward.
6. Remove the 2 front seat-to-floor bolts.

60 percent seat

7. NOTE: The SuperCab and regular cab safety belts route differently. Note belt position for correct installation.

Route the front center safety belt buckle through the locating strap on the side of the seat.







All seats
8. Disconnect the electrical connector and remove the seat.

Installation

NOTE: The seat track-to-floor bolts must be tightened in the sequence described in this procedure.

All seats
1. Position the seat in the vehicle.
2. Connect the seat electrical connector.

60 percent seat

3. NOTE: SuperCab and regular cab safety belts route differently, make sure of correct routing.

Position the seat fully forward and route the front center safety belt buckle through the locating strap on the side of the seat.







4. Install the front center safety belt bolt.
- Tighten to 55 Nm (41 lb-ft).
- If equipped, slide the front center safety belt bolt cover on the front center safety belt and position in place.







All seats
5. Position the seat fully rearward and install the front inboard seat-to-floor bolt.
- Tighten to 55 Nm (41 lb-ft).

6. Install the front outboard seat-to-floor bolt.
- Tighten to 55 Nm (41 lb-ft).

7. Position the seat fully forward and install the rear inboard seat-to-floor bolt.
- Tighten to 55 Nm (41 lb-ft).

8. Install the rear outboard seat-to-floor bolt.
- Tighten to 55 Nm (41 lb-ft).
- Make sure the safety belts and buckles are accessible to the occupants after installation.

9. Repower the SRS.