Test A: The Parking Brake Does Not Apply
Pinpoint Test A: The Parking Brake Does Not ApplyNormal Operation
When the parking brake control pedal is pressed, the pedal should move a short distance, with more pressure needed to apply the pedal as it gets closer to the floor, until the parking brake is fully applied. When the parking brake control is pressed, tension is applied to the intermediate parking brake cable. This tension pulls on the RH rear parking brake cable, which is attached to the RH rear parking brake actuator and applies the RH rear brake shoes. At the same time, the tension in the RH rear parking brake cable causes the RH rear cable conduit to attempt to straighten out. This straightening effect causes tension that pulls the LH rear cable which is attached to the LH rear parking brake actuator and applies the LH rear brake shoes.
This pinpoint test is intended to diagnose the following:
^ Front parking brake cable and conduit
^ Intermediate parking brake cable and conduit
^ Parking brake control
^ Rear brake hardware
^ Rear brake shoes and linings
A1-A5:
A6:
