Cruise Control Servo: Service and Repair

SPEED CONTROL ACTUATOR







Removal and Installation
1. Disconnect the speed control actuator electrical connector.
2. Remove the speed control cable cap from the speed control actuator.
- Push in the locking arm on the speed control cable cap and rotate the cap counterclockwise.







3. Remove the speed control cable.
1 Press the spring retainer.
2 Slide the core wire end out of the speed control actuator pulley and remove the speed control cable.







4. Remove the bolt and the speed control actuator and bracket assembly.
- To install, tighten to 11 Nm (8 lb-ft).

5. Remove the 3 bolts and separate the speed control actuator bracket from the speed control actuator.
- To install, tighten to 9 Nm (80 lb-in).







6. NOTE: Make sure the rubber seal is fully seated onto the speed control cable cap.

To install, reverse the removal procedure.