Test G: DTC B2293 - Restraint System - Air Bag Fault
PINPOINT TEST G: DTC B2293 - RESTRAINT SYSTEM - AIR BAG FAULTNormal Operation
The restraints control module (RCM) monitors all front air bag module circuits for faults. The RCM will set a DTC if a short to battery or short to ground fault is detected. The RCM will also set a DTC if the loop resistance is less than 1.31 ohm or greater than 5 ohms. The normal expected resistance range is 1.31 to 4.29 ohms. If a loop resistance is between 0.9 and 1.31 or between 4.29 and 5 ohms, there exists a strong potential for an intermittent fault. If the RCM detects a fault on any of the front air bag circuits, it will store DTC B2293 in memory and send a message to the instrument cluster (IC) module to illuminate the air bag warning indicator.
Part 1:
Part 2:
This pinpoint test is intended to diagnose the following:
- Wiring, terminals or connectors
- Clockspring
- Driver or passenger air bag module
- RCM
G1:
G2:
G2-G5:
G5-G7:
G7-G8:
G9-G11:
G11-G13:
G13-G15:
G15-G16:
G17-G19:
G19-G20:
G20-G22:
G22-G24:
G24-G25:
G26-G28:
G28-G30:
G30-G32:
G32-G33:
G34-G36:
G36-G37:
G38:
