Key Release Button

Key Release Button

Key Release Button:

Removal and Installation
1. Remove the ignition switch lock cylinder.
1 Insert the ignition key into the ignition switch lock cylinder and turn to the RUN position.
2 Push the ignition switch lock cylinder release tab with a punch while pulling out the ignition switch lock cylinder.
2. If equipped, remove the tilt release lever/ handle.
3. Remove the 3 steering column shroud screws and the upper and lower steering column shrouds.
4. Remove the key release button bolt and the key release button and spring.
^ To install, tighten to 5 Nm (44 lb-inch).

5. To install, reverse the removal procedure.