Passenger Air Bag Module

PASSENGER AIR BAG MODULE







Removal

WARNING:
- Always wear eye protection when servicing a vehicle. Failure to follow this instruction may result in serious personal injury.
- Always carry or place a live air bag module with the air bag and deployment door/trim cover/tear seam pointed away from the body. Do not set a live air bag module down with the deployment door/trim cover/tear seam face down. Failure to follow these instructions may result in serious personal injury in the event of an accidental deployment.
- Never probe the electrical connectors on air bag, safety canopy or side air curtain modules. Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.
- Do not repaint air bag modules with discolored or damaged trim covers or deployment doors; new air bag modules must be installed. Failure to follow this instruction may result in the air bag deploying incorrectly, which increases the risk of serious personal injury or death in a crash.

NOTE:
- The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic procedure again.

1. Depower the SRS.
2. Open and lower the glove compartment door.
3. Disconnect the passenger air bag module electrical connector.
4. Remove the 2 passenger air bag module bolts.

5. CAUTION: Do not handle the passenger air bag module by grabbing the edges of the deployment doors. Damage to the air bag module may occur.

Placing one hand in the glove compartment, push the passenger air bag module out and remove it.
- If necessary, push down on the top and up on the bottom of the deployment door while pushing out on the passenger air bag module, releasing the clips from the instrument panel and remove the passenger air bag module.







Installation

1. CAUTION: Do not handle the passenger air bag module by grabbing the edges of the deployment doors. Damage to the air bag module may occur.

Position the passenger air bag module into the instrument panel.
- Angle the top of the passenger air bag module into the instrument panel first so that the deployment door upper clips engage to the instrument panel. Push up and in at the top and down and in at the bottom of the deployment door to seat all the clips to the instrument panel.







2. Align the passenger air bag module and install the 2 bolts.
- Tighten to 8 Nm (71 lb-in).

3. Connect the passenger air bag module electrical connector.
4. Close the glove compartment door.
5. Repower the SRS.