Flywheel: Service and Repair

Flywheel

Flexplate or Flywheel and Crankshaft Rear Seal - Exploded View

Flexplate or Flywheel and Crankshaft Rear Seal - Exploded View:

Removal
1. Remove the clutch.
2. Remove the bolts and the flywheel.

Installation

1. NOTE: Special bolts are used for flywheel installation. Do not use standard bolts.

Position the flywheel and install the bolts. Tighten the bolts in the sequence shown in 3 stages.
^ Stage 1: Tighten to 13 Nm (10 lb-ft).
^ Stage 2: Tighten to 50 Nm (37 lb-ft).
^ Stage 3: Tighten an additional 90 degrees.





2. Install the clutch.