Power Seat Motor: Service and Repair

POWER-FOLD SEAT MOTOR

Exploded View

Taurus X Rear Seat Backrest, Second Row, 40 Percent:

Taurus X Rear Seat Cushion, Second Row, Manual 40 Percent (Part 1):

Taurus X Rear Seat Cushion, Second Row, Manual 40 Percent (Part 2):

Taurus X Rear Seat Cushion, Second Row, Power-Fold 40 Percent (Part 1):

Taurus X Rear Seat Cushion, Second Row, Power-Fold 40 Percent (Part 2):

Taurus X Rear Seat Backrest, Second Row, 60 Percent:

Taurus X Rear Seat Cushion, Second Row, 60 Percent (Part 1):

Taurus X Rear Seat Cushion, Second Row, 60 Percent (Part 2):

Removal and Installation
1. Remove the affected second row seat.

2. NOTE: It is not necessary to remove the hog rings or separate the cushion trim cover and cushion foam pad.

Remove the cushion trim cover and cushion foam pad.
- Disconnect the cushion heater mat electrical connector and release the pin-type retainer.

3. Remove the screw and recliner handle.
4. Remove the outer recliner trim cover from the outboard side.
- Remove the screw.
- Release the retainer tabs and separate the trim covers.
- Route the pull strap through the hole in the trim cover.

5. Disconnect the power-fold seat motor cable from the recliner.
- Disconnect the cable jacket from the cable clamp.
- Rotate the cable end guide to release.







6. Remove the 2 screws and detach the power-fold seat motor.
7. Loosen the 2 recliner-to-cushion frame bolts, route the cable from the cushion frame and remove the power-fold seat motor.
- To install, tighten to 50 Nm (37 lb-ft).

8. To install, reverse the removal procedure.