Seat - Third Row

SEAT - THIRD ROW

Removal and Installation







1. Remove the left and right side rear quarter trim panels.

2. NOTE: 50/50 percent seat shown, bench seat similar.

Remove the 2 load floor supports (1 shown) from the load floor panel(s).
- Push the load floor support back and lift up on the load floor to disengage.







3. Remove the 4 bolts and remove the third row seat.
- To install, tighten to 80 Nm (59 lb-ft).

4. To install, reverse the removal procedure.
- Make sure the safety belt buckles are accessible to the occupants after installation.