Brake Caliper Anchor Plate, Front

Brake Caliper Anchor Plate

Disc Brake System - Exploded View (Part 1):

Disc Brake System - Exploded View (Part 2):

Removal
1. Remove the brake pads.
2. Remove and discard the 2 brake caliper anchor plate bolts and remove the brake caliper anchor plate.
^ Make sure the steering stop is supported when the brake caliper anchor plate bolts are removed.

3. NOTE: Do not remove the anchor plate guide pins. The guide pins are press fit to the brake caliper anchor plate. If the guide pins are damage a new anchor plate must be installed.

Inspect the brake caliper anchor plate assembly.
^ Check the guide pins and boots for binding or damage.
^ Install a new brake caliper anchor plate if it is worn or damaged.

Installation
1. Position the brake caliper anchor plate and steering stop on the wheel knuckle and install 2 new bolts.
^ Tighten to 150 Nm (111 lb-ft).
2. Install the brake pads.