Battery Cable: Service and Repair

BATTERY CABLES

Part 1:

Part 2:

Removal and Installation
1. Remove the battery tray.
2. Remove the bolt and position the battery cable body ground terminal aside.
- To install, tighten to 12 Nm (9 lb-ft).

3. Remove the nut and position the battery junction box (BJB) cable terminal aside.
- To install, tighten to 8 Nm (71 lb-in).

4. Remove the starter solenoid terminal cover.
5. Remove the nut and position the battery cable starter solenoid terminal aside.
- To install, tighten to 12 Nm (9 lb-ft).

6. Remove the nut and position the battery cable starter motor terminal aside.
- To install, tighten to 12 Nm (9 lb-ft).

7. Release the battery cable locator from the engine.
8. Remove the bolt and position the battery cable engine ground terminal aside.
- To install, tighten to 12 Nm (9 lb-ft).

9. Release the battery cable from the top of the intake manifold.
10. Release the 3 battery cable locators from the LH valve cover.
11. Position the generator protective cover aside, remove the nut and position the generator B+ terminal aside.
- To install, tighten to 12 Nm (9 lb-ft).

12. Remove the battery cables.
13. To install, reverse the removal procedure.