Electronic Brake Control Module: Service and Repair

Anti-Lock Brake System (ABS) Module

Anti-Lock Brake System (ABS) Module:

Removal and Installation

CAUTION: Electronic modules are sensitive to electrical charges. The anti-lock brake system (ABS) module can be damaged if exposed to these charges.

NOTE: When installing a new ABS module, it must be configured (using vehicle as-built data) and calibrated. Follow the scan tool directions for the calibration procedures.

1. Remove the hydraulic control unit (HCU).
2. Remove and discard the 4 screws.
^ To install, tighten the new screws to 3 Nm (27 lb-in).
3. Remove the ABS module.
4. To install, reverse the removal procedure.