Parking Brake Cable - Rear, LH

Parking Brake Cable - Rear, LH

NOTE: Rear disc shown, rear drum similar.










Removal and Installation

1. Release the parking brake cable tension. For additional information, refer to Parking Brake Cable Tension Release Procedures.

2. Remove the rear brake shoes.

3. Disconnect the parking brake cable from the cable connector and the equalizer bracket by compressing the cable conduit locking tabs.

4. Detach the cable-to-fuel tank strap pin type retainer.

5. Remove the 2 parking brake cable bracket bolts.
- To install, tighten to 23 Nm (17 lb-ft).

6. Compress the rear parking brake cable conduit locking tabs and pull the cable assembly through the brake backing plate.





7. To install, reverse the removal procedure.