Headliner: Service and Repair

Headliner









Removal and Installation

1. Remove the LH and RH A-pillar trim panels. For additional information, refer to A-Pillar Trim Panel A-Pillar Trim Panel.

2. Remove the LH and RH B-pillar trim panels. For additional information, refer to B-Pillar Trim Panel B-Pillar Trim Panel.

3. Remove the LH and RH C-pillar trim panels. For additional information, refer to C-Pillar Trim Panel C-Pillar Trim Panel.

4. Remove the LH and RH D-pillar trim panels. For additional information, refer to D-Pillar Trim Panel D-Pillar Trim Panel.

5. Open the overhead console door.





6. Remove the 2 screws and the overhead console.
- Disconnect the electrical connector.





7. Remove the LH and RH sun visors.
- If equipped, disconnect the electrical connectors.

8. NOTE: Do not fully remove the retaining screws from the sun visor clips.

Remove the LH and RH sun visor clips.

- Partially remove the retaining screws from the sun visor clips.

- Pull downward on the sun visor clips to remove them from the headliner.

9. Using a small flat screwdriver, release and remove the interior lamp lens.

10. Remove the interior lamp.
- Early build, remove the 2 screws.

- Late build, remove the 2 pushpins.

- Disconnect the electrical connector.

11. Remove the cargo lamp.
- Disconnect the electrical connector.

12. Remove the 3 child seat tether anchor covers.





13. Remove the 3 bolts and the child seat tether anchors.
- To install, tighten to 22 Nm (16 lb-ft).





14. If equipped, remove the screw and the garment hook.
- Open the garment hook screw cover.

- Remove the garment hook screw.
- To install, tighten to 7 Nm (62 lb-in).





15. NOTE: When installing the headliner trim ring, it should meet at the rear of the roof opening and have no gaps or overlaps.

If equipped, remove the headliner trim ring.

16. Remove the 5 headliner pin-type retainers.

17. Remove the headliner.

18. To install, reverse the removal procedure.
- Transfer parts as necessary.