C-Pillar Trim Panel

C-Pillar Trim Panel

Removal and Installation

Early and late build

1. NOTE: Inspect the safety belt D-ring cover for damage. If the safety belt D-ring cover does not remain in place, install a new cover.

Remove the safety belt D-ring bolt cover.





2. Remove the safety belt bolt.
- To install, tighten to 48 Nm (35 lb-ft).





3. Remove the quarter trim panel. For additional information, refer to Quarter Trim Panel .

4. Position the rear door weatherstrip aside.

Early build

5. NOTICE: To avoid damage to the C-pillar trim panel, remove any retaining clips from the body and attach them to the C-pillar trim panel before installing.

Remove the cover, the bolt and the C-pillar trim panel.

- To install, tighten to 7 Nm (62 lb-in).





Late build

6. Release the C-pillar coat hook by inserting a small flat screwdriver in the slot at the base of the coat hook.





7. Remove the coat hook.
- LH coat hook, twist clockwise.

- RH coat hook, twist counterclockwise.

8. Remove the C-pillar trim panel bolt.
- To install, tighten to 7 Nm (62 lb-in).

Early and late build

9. To install, reverse the removal procedure.