Coolant Pump Housing

Coolant Pump Housing - 3.0L (4V)

Coolant Hoses










Coolant Pump Housing









Removal and Installation

1. With the vehicle in NEUTRAL, position it on the hoist.

2. Drain the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding Service and Repair.

3. Remove the Air Cleaner (ACL) outlet pipe.

4. Disconnect the upper radiator hose from the coolant pump housing.

5. Disconnect the lower radiator hose from the thermostat housing.

6. Disconnect both heater hoses from the coolant pump housing.

7. Remove the 3 bolts, 2 nuts and the coolant pump housing.
- Remove and discard the O-ring seals and gasket.

- To install, tighten to 10 Nm (89 lb-in).

8. To install, reverse the removal procedure.
- Install new O-ring seals and gasket.

9. Fill and bleed the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding Service and Repair.