Transmission Insulator and Retainer - Lower

Transmission Insulator and Retainer - Lower

Removal and Installation

Transmission Insulator and Retainer - Lower









1. With the vehicle in NEUTRAL, position it on a hoist.

2. Turn the ignition to the OFF position.

3. Remove the splash shield retainers and remove the LH splash shield.





4. Remove the bolts and the lateral support crossmember.
- To install, tighten to 115 Nm (85 lb-ft).





5. Remove the lower insulator through bolt.
- To install, tighten to 115 Nm (85 lb-ft).





6. Remove the rear roll restrictor-to-crossmember through bolt.
- To install, tighten to 90 Nm (66 lb-ft).





7. Remove and discard the engine support crossmember nut. Remove the 2 engine support crossmember bolts.
- To install, tighten the new engine support crossmember nut to 175 Nm (129 lb-ft).

- To install, tighten the 2 engine support crossmember bolts to 90 Nm (66 lb-ft).





8. Remove the engine support crossmember.

9. Remove the rear roll restrictor through bolt and remove the rear roll restrictor from the bracket.
- To install, tighten to 90 Nm (66 lb-ft).





10. To install, reverse the removal procedure.