Stub Shaft Seal

Stub Shaft Seal









Removal

1. NOTE: There is no bearing for the stud shaft. There is a seal only.

Remove the halfshaft assembly.

2. Use the Torque Converter Fluid Seal Remover and Slide Hammer to remove the stub shaft seal.





Installation

1. NOTE: Lubricate the new stub shaft seal with grease.

Using the Front Axle Oil Seal Installer and Handle, install the stub shaft seal.





2. NOTE: Inspect the inboard CV joint seal journal for rust or nicks/scratches prior to installing the halfshaft. If necessary, polish the seal journal with fine crocus cloth.

Install the halfshaft assembly.