Lumbar Assembly

Lumbar Assembly

Removal and Installation

NOTE: For component identification and locations, refer to Seat - Exploded View, Front Seat - Exploded View, Front.

All seats

1. Remove the seat. For additional information, refer to Seat - Front Seat - Front.

2. Remove the seat backrest. For additional information, refer to Seat Backrest - Front Seat Backrest - Front.

3. Raise the backrest cover rear flap and release the foam pad flap from the backrest frame hooks.

4. Position aside the backrest cover and foam pad to gain access to the lumbar assembly bolts.

5. Remove the 4 bolts and lumbar assembly.
- To install, tighten to 7 Nm (62 lb-in).

- If equipped, disconnect the electrical connector from the lumbar assembly.

- If equipped, route out the manual lumbar cable.

Manual lumbar actuator removal

6. Remove the 2 screws and manual lumbar actuator.
- Note manual lumbar cable routing for correct installation.

All seats

7. To install, reverse the removal procedure.