Compressor To Condenser Discharge Line

Compressor to Condenser Discharge Line - 4.6L













Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Recover the refrigerant.

3. Remove the Air Cleaner (ACL) and ACL outlet tube. Service and Repair

4. Remove the compressor-to-condenser discharge line bracket nut and detach the bracket.
- To install, tighten to 9 Nm (80 lb-in).

5. Remove the compressor outlet fitting nut and disconnect the fitting.
- Discard the O-ring seal and gasket seal.

- To install, tighten to 15 Nm (133 lb-in).

6. Remove the 2 coolant expansion tank bolts and position the coolant expansion tank aside.
- To install, tighten to 7 Nm (62 lb-in).

7. Disconnect the A/C pressure transducer electrical connector.

8. Remove the condenser inlet fitting nut and disconnect the fitting.
- Discard the O-ring seal.

- To install, tighten to 8 Nm (71 lb-in).

9. NOTE: The LH clip should be disconnected from the line. The RH clip should be disconnected from the cooling module.

Detach the 2 compressor-to-condenser discharge line clips at the cooling module.

10. Remove the compressor-to-condenser discharge line.

11. To install, reverse the removal procedure.
- Install a new gasket seal and O-ring seals.

- Lubricate the refrigerant system with the correct amount of clean PAG oil.

12. Evacuate, leak test and charge the refrigerant system.