Pinpoint Test Q: The Speed Control Indicator Is Never/Always On

Instrumentation, Message Center and Warning Chimes

Pinpoint Tests

Pinpoint Test Q: The Speed Control Indicator Is Never/Always On

Normal Operation

The speed control status information is sent to the Instrument Cluster (IC) from the PCM over the High Speed Controller Area Network (HS-CAN). When the speed control is engaged, the PCM provides a signal to the IC to illuminate the speed control indicator.

This pinpoint test is intended to diagnose the following:

- Speed control system concern
- PCM
- IC



PINPOINT TEST Q: THE SPEED CONTROL INDICATOR IS NEVER/ALWAYS ON

-------------------------------------------------
Q1 CHECK THE SPEED CONTROL OPERATION


- Verify the speed control operates correctly.
- Does the speed control operate correctly?

Yes
GO to Q2.

No
REFER to Cruise Control.

-------------------------------------------------
Q2 RETRIEVE THE RECORDED DTCs FROM THE IC SELF-TEST


- Check for recorded IC DTCs from the self-test.
- Are any DTCs recorded?

Yes
For DTC U1900, REFER to Information Bus.

For all other DTCs, REFER to DTC Charts. Instrumentation, Message Center and Warning Chimes

No
GO to Q3.

-------------------------------------------------
Q3 CARRY OUT THE IC INDICATOR LAMP ACTIVE COMMAND USING THE SCAN TOOL


- Ignition ON.
- Enter the following diagnostic mode on the scan tool: IC DataLogger.
- Select the IC speed control indicator (CRUISE) active command. Command the speed control indicator on and off. Observe the speed control indicator.
- Does the speed control indicator illuminate when commanded on, and turn off when commanded off?

Yes
INSTALL a new PCM. TEST the system for normal operation.

No
INSTALL a new IC. REFER to Instrument Cluster (IC) Instrument Cluster (IC). TEST the system for normal operation.

-------------------------------------------------