Universal Serial Bus (USB) Cable and Port

Universal Serial Bus (USB) Cable and Port

Floor Console Components










Universal Serial Bus (USB) Cable And Port-To-Bezel










USB Cable And Port-To-Accessory Protocol Interface Module (APIM)









Removal and Installation

1. Remove the 4 screws and the front floor console stowage door.

2. Remove the 2 screws and the front floor console rear trim panel.
- Pull straight back to disengage the clips.

3. Remove the 2 screws and the front floor console finish panel.
- Pull straight up to disengage the clips.

4. Using a suitable tool (such as a trim removal tool) pry the audio input jack bezel from the storage bin.
- Disconnect the audio input jack electrical connector.

5. Disconnect the Universal Serial Bus (USB) port connector from the audio input jack bezel.

6. Remove the 4 screws and the front floor console stowage bin.

7. Remove the USB cable and port.
- Disconnect the electrical connector.

8. To install, reverse the removal procedure.