Extension Housing Seal

Extension Housing Seal - Rear Wheel Drive (RWD)













Removal

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Remove the driveshaft.

3. Using the Torque Converter Fluid Seal Remover and Slide Hammer, remove the extension housing seal.





Installation

1. NOTE: Make sure the extension housing seal is correctly installed onto the Transmission Extension Housing Oil Seal Installer and the garter spring is in the correct position.

Using the Transmission Extension Housing Oil Seal Installer, install the extension housing seal.





2. Install the driveshaft.

3. Carry out the transmission fluid level check. For additional information, refer to Transmission Fluid Level Check Transmission Fluid Level Check.