Timing Cover
Crankshaft PulleyUsing a new crankshaft pulley bolt, install the bolt and washer and tighten the bolt in 4 stages.
- Stage 1: Tighten to 90 Nm (66 lb-ft)
- Stage 2: Loosen 360 degrees
- Stage 3: Tighten to 50 Nm (37 lb-ft)
- Stage 4: Tighten an additional 90 degrees
Timing Cover
Tighten the 15 engine front cover fasteners in the sequence shown in 2 stages.
- Stage 1: Tighten fasteners 1 through 15 to 25 Nm (18 lb-ft)
- Stage 2: Tighten fasteners 6 and 7 to 48 Nm (35 lb-ft)
Loosely install the 4 bolts, then tighten in 2 stages, in the sequence shown.
- Stage 1: Tighten to 20 Nm (177 lb-in)
- Stage 2: Tighten an additional 60 degrees
Variable Camshaft Timing (VCT) Housing
RH VCT housing
Position the RH VCT housing and install the 2 bolts.
- Tighten to 10 Nm (89 lb-in)
LH VCT housing
Position the LH VCT housing and install the 2 bolts.
- Tighten to 10 Nm (89 lb-in)