Pinpoint Test G: The Keyless Entry Keypad Illumination Is Inoperative/Does Not Operate Correctly

Locks, Latches and Entry Systems







Pinpoint Test G: The Keyless Entry Keypad Illumination Is Inoperative/Does Not Operate Correctly

Refer to Wiring Diagram Set 117, Remote Keyless Entry and Alarm for schematic and connector information. Diagrams By Number

Normal Operation

When the Smart Junction Box (SJB) detects that a keyless entry button is pressed, the SJB provides voltage for the keyless entry keypad illumination through circuit CPK28 (WH/GN). Ground for the keyless entry keypad illumination is provided through circuit GD134 (BK/VT).

- DTC B1624 (Lamp Keypad Output Open Circuit) - a continuous and on-demand DTC that sets when the SJB detects an open or short to battery on the keyless entry keypad illumination circuit CPK28 (WH/GN).
- DTC B1626 (Lamp Keypad Output Short Circuit to Ground) - a continuous DTC that sets when the SJB detects a short to ground on the keyless entry keypad illumination circuit CPK28 (WH/GN).

This pinpoint test is intended to diagnose the following:

- Wiring, terminals or connectors
- Keyless entry keypad
- SJB



PINPOINT TEST G: THE KEYLESS ENTRY KEYPAD ILLUMINATION IS INOPERATIVE/DOES NOT OPERATE CORRECTLY

NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.

NOTE: Failure to disconnect the battery when instructed will result in false resistance readings. Refer to Battery.

G1-G5:

G5-G8:

G8-G11: