Programming Memory Positions

Memory Position Programming

Programming Memory Positions

NOTE: Memory positions can be stored at any time.

NOTE: Verify good battery condition before diagnosing the memory seat system. Poor battery condition may interfere with memory seat operation, even if vehicle starting is possible.

1. Place the vehicle ignition to ON.

2. NOTE: To program an Integrated Keyhead Transmitter (IKT) (remote entry transmitter), refer to Remote Keyless Entry Transmitter Programming and Remote Memory Activation in Power Locks.

To set memory position(s), move the memory driver seat, memory exterior mirrors (if equipped), memory adjustable pedals (if equipped) and memory tilt steering column (if equipped) to the preferred position using the appropriate switch(es).

3. NOTE: Activation of the driver seat control switch, adjustable pedal control switch (if equipped), exterior mirror control switch (if equipped) or power tilt steering column switch (if equipped) during memory programming will abort the operation.

Select the memory position.

- For 3-button memory SET switch:

- NOTE: Once the memory SET switch button is pressed, there is a 5-second time limit to input a memory position. If a memory position input is not received within the time limit, the operation is aborted and the memory SET switch indicator (if equipped) is turned OFF.

Press the SET button (the memory SET switch indicator will illuminate).

- Press button 1 or 2 within 5 seconds (before the indicator goes out).

- For 2-button memory SET switch:

- NOTE: If other tones or chimes are being produced, the memory save tone will not be heard because it is one of the lowest priorities.

Press and hold a memory button (1 or 2) until a tone is heard (1.5 seconds). When the tone is heard, the memory programming is complete.

4. Repeat the previous steps to program another memory position.