Speed Control Deactivator Switch

Speed Control Deactivator Switch





Removal

NOTICE: Make sure the master cylinder reservoir cap is secure before performing this procedure.

1. Disconnect the battery.

2. Disconnect the deactivator switch electrical connector.





3. NOTICE: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.

NOTICE: Do not allow any foreign matter to enter the master cylinder port once the deactivator switch is removed.

Remove the deactivator switch.

Installation

1. NOTICE: Do not allow brake fluid to contact the electrical connector.

Install the deactivator switch.

- Add a few drops of brake fluid to the fluid port on the threaded side of the switch before installing it.

- To install, tighten to 18 Nm (159 lb-in).









2. Check the master cylinder fluid level and adjust as necessary.

3. Connect the battery.