Seat Control Switch - Front

Seat Control Switch - Front

Removal

NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.

1. WARNING: Turn the ignition OFF and wait one minute to deplete the backup power supply. Failure to follow this instruction may result in serious personal injury or death in the event of an accidental deployment.

For passenger seat, turn the ignition OFF and wait at least one minute.

2. For driver seat, remove the manual recliner handle, if equipped.

1. Locate the clip between the seat cushion and side shield.

2. Remove the clip and slide the handle off the shaft.





3. For passenger seat, remove the manual recliner handle in the following sequence.

1. Pull the back flap out to access the recliner handle clip.

2. Locate the clip between the seat cushion and side shield.

3. Remove the clip and slide the handle off the shaft.





4. If equipped, remove the manual lumbar knob.

1. Locate the clip between the seat cushion and side shield.

2. Remove the clip and slide the knob off the shaft.





5. For driver seat, pull out and remove the cushion side shield cover.

6. For passenger seat, release the 3 clips, slide rearward and remove the cushion side shield cover.





7. Separate the safety belt anchor from the seat.
- For driver seat, remove the safety belt anchor bolt and separate the safety belt anchor from the seat.

- For passenger seat, disconnect the Belt Tension Sensor (BTS) electrical connector, remove the safety belt anchor bolt and separate the safety belt anchor from the seat.

8. Separate the cushion side shield.

1. Remove the scrivet at the rear of the cushion side shield.

2. Remove the screw at the rear of the cushion side shield.

3. Remove the screw at the front of the cushion side shield.

4. Pull out to release the clips and separate the cushion side shield.





9. Separate the wire harness pin-type retainer, disconnect the seat control switch and remove the cushion side shield.





10. Pull the seat control switch knob(s) off the switch.

11. Release the retainers and remove the seat control switch.

Installation

1. Align the seat control switch to the cushion side shield and push in, engaging the retainers.

2. Install the seat control switch knob(s) onto the switch.

3. Connect the seat control switch electrical connector and attach the wire harness pin-type retainer to the cushion frame.

4. Attach the cushion side shield in the following sequence.

1. Return all retaining clips back to the cushion side shield before attaching to the seat.

2. Align the 4 cushion side shield clips to the seat and push in seating the clips.

3. Install the screw at the front of the cushion side shield.

4. Install the screw at the rear of the cushion side shield.

5. Install the scrivet at the rear of the cushion side shield.

5. For passenger seat, insert the flap back.

6. Install the safety belt anchor bolt.
- Tighten to 40 Nm (30 lb-ft).

- For passenger seat, connect the BTS electrical connector.

7. Install the cushion side shield cover.

8. If equipped, install the manual lumbar knob in the following sequence.

1. Install the clip onto the manual knob handle.

2. Align the splines of the manual lumbar knob to the manual lumbar shaft.

3. Push the manual lumbar handle onto the manual lumbar shaft, seating the clip.

9. If equipped, install the manual recliner handle in the following sequence.

1. Install the clip onto the manual recliner handle.

2. Align the splines of the manual recliner handle to the manual recliner shaft.

3. Push the manual recliner handle onto the manual recliner shaft, seating the clip.

10. For passenger seat, carry out the Occupant Classification Sensor (OCS) System Reset. For additional information, refer to the General Procedures of Air Bag Systems.