Instrument Panel Finish Panel - RH

Instrument Panel Finish Panel - RH

Removal and Installation

1. NOTE: The ignition switch must be in the OFF position for at least 1 minute if disconnecting the Passenger Air Bag Deactivation (PAD) indicator electrical connector. Otherwise, a DTC will be set in the Restraints Control Module (RCM) memory and must be cleared before releasing the vehicle.

Position the ignition switch to the OFF position.

2. Remove the RH instrument panel finish panel.
- Starting at the RH side of the RH instrument panel finish panel, use a non-marring tool to pry the RH instrument panel finish panel outward to release the retaining clips.
- Disconnect the electrical connectors.





3. To install, reverse the removal procedure.
- Make sure to align the retaining clips to the adjacent retaining clip holes.