Arm Rest: Service and Repair

Seat Armrest - Rear

Removal and Installation

1. Remove the 60 percent rear seat backrest. For additional information, refer to Seat Backrest - Rear Rear Seat.

2. Release the lower J-strip and partially invert the backrest trim cover to access the armrest-to-backrest bolts.

3. Remove the 4 armrest-to-backrest bolts and support plate.
- For installation, adjust the armrest horizontally as needed for good fit.

- To install, tighten to 10 Nm (89 lb-in).

4. Separate the armrest and bracket assembly from the backrest and position aside.
- For installation, align the armrest bracket locator tab to the backrest frame.

5. Release the 4 pin-type retainers, separate the armrest trim cover panel from the backrest and remove the armrest assembly.
- For a broken retainer, push the remaining end through and into the backrest frame and install a new pin-type retainer during installation.





6. To install, reverse the removal procedure.