Output Shaft Speed (OSS) Sensor

Output Shaft Speed (OSS) Sensor





Output Shaft Speed (OSS) Sensor









Removal

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Place a drain pan beneath the Output Shaft Speed (OSS) sensor.

3. Remove the OSS sensor.
- Disconnect the OSS electrical connector.

- Remove the OSS bolt.

- Inspect the OSS bore.





4. Inspect the OSS O-ring seal for nicks or cuts, install a new OSS O-ring if necessary.





Installation

1. NOTE: Apply a light coat of petroleum jelly to the O-ring before installation.

Install the OSS sensor.

- Tighten the OSS sensor bolt to 10 Nm (89 lb-in).

- Connect the OSS electrical connector.





2. Check the transmission fluid level and add transmission fluid as necessary.





3. Start the engine and move the selector lever through all gear positions.