Extension Housing Seal

Extension Housing Seal









Extension Housing Seal









Removal

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

2. Remove the driveshaft. For additional information, refer to Drive/Propeller Shafts, Bearings and Joints.

3. Using the Transmission Fluid Seal Remover and Slide Hammer, remove the extension housing seal.





Installation

1. NOTE: When installing the new seal, make sure that the drain hole in the seal is in the 6 o'clock position.

Using the Transmission Extension Housing Oil Seal Installer, install a new extension housing seal.





2. Install the driveshaft. For additional information, refer to Drive/Propeller Shafts, Bearings and Joints.

3. Check the transmission fluid level, add transmission fluid as necessary.
- Verify for correct operation.

- Check for leaks.