Exhaust Manifold - RH

Exhaust Manifold - RH













Removal

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

2. Disconnect the battery ground cable. For additional information, refer to Battery.

3. Remove the engine cover.

4. Prior to removing the exhaust manifold, inspect the exhaust manifold for warpage with a feeler gauge between the manifold and the cylinder head. Record the measurement and compare with the specifications.

5. Remove the 2 RH exhaust manifold-to-turbocharger adapter pipe nuts.
- Discard the nuts.

6. Remove the 8 bolts, 8 spacers and the RH exhaust manifold.
- Discard the bolts.

Installation

1. NOTE: Start installing the bolts with the second bolt from the rear on the top. The hole diameter is smaller, therefore allowing alignment of the remaining bolts.

NOTE: When installing the exhaust manifolds, only use prevailing torque hex flange bolts with an interference fit.

NOTE: Apply anti-seize lubricant to the bolt threads prior to installing the bolts.

Install the RH exhaust manifold, 8 spacers and 8 new bolts. Tighten the bolts in the sequence shown.

- Tighten to 38 Nm (28 lb-ft).





2. NOTE: Apply anti-seize lubricant to the bolt threads prior to installing the bolts.

Install the 2 new RH exhaust manifold-to-turbocharger adapter pipe nuts.

- Tighten to 27 Nm (20 lb-ft).

3. Install the engine cover.

4. Connect the battery ground cable. For additional information, refer to Battery.