Part 2

Engine






36. NOTE: Cover removed for clarity.

Remove the nut and the battery feed cable at the Power Distribution Box (PDB).





37. Disengage the harness routing clips and position aside the battery feed wiring harness.





38. If equipped, disconnect the air temperature sensor electrical connector.





39. Disconnect the front impact severity sensor electrical connector.





40. Disconnect the horn electrical connector.





41. Disconnect the transmission fluid cooler hose retainers.





42. Remove the bolt and position the transmission fluid cooler aside.





43. NOTE: RH shown, LH similar.

Remove the pin-type retainers and the RH and LH air deflectors.





44. NOTE: RH shown, LH similar.

Remove the 4 bolts and the 2 upper radiator support plates.





45. NOTE: RH shown, LH similar.

Remove the 8 bolts and the upper radiator support.





46. Remove the bolt and disconnect the 2 headlamp wiring harness retainers.





47. Disconnect the 4 wiring harness retainers and position the wiring harness aside.





48. Remove the 12 bolts and the lower radiator support.





49. Disconnect the lower radiator hose from the oil filter adapter water inlet and position aside.





50. Disconnect the engine wiring harness retainer and the 2 PCM electrical connectors.





51. Disconnect the engine wiring harness electrical connectors.





52. Disconnect the generator wiring harness retainer and position the wiring harness aside.





53. Disconnect the electrical connectors, remove the nut, ground strap and mounting bracket.





54. Remove the engine oil filler tube support strap bolt.





55. Remove the fluid level indicator and disconnect the attachments at the transmission fluid filler tube.

1. Remove the fluid level indicator.

2. Disconnect the rear heater hose hanger.





56. Disconnect the RH Heated Oxygen Sensor (HO2S) electrical connector and remove the transmission fluid filler tube.





57. Disconnect the RH HO2S sensor wiring harness retainer from the heater coolant outlet tube bracket.





58. Disconnect the hose from the heater outlet tube.





59. Remove the 2 heater outlet tube studs.





60. Remove the heater outlet tube.
- Discard the O-ring seals.





61. Disconnect the transmission wiring harness retainers from the engine wiring harness.





62. Disconnect the LH HO2S sensor electrical wiring harness retainer from the rear of the LH cylinder head.





63. Disconnect the transmission wiring harness retainer and position the transmission wiring harness aside.





64. Disconnect the LH HO2S sensor electrical connector and retainer.





65. Remove the bolt and position the ground wire aside.





66. Remove the 4 upper transmission-to-engine bolts and position the fuel tube support bracket aside.





67. Install the Engine Lifting Bracket as shown.





68. Support the transmission with a jack.

69. Remove the engine from the vehicle.