Ignition Coil-On-Plug

Ignition Coil-On-Plug





Removal and Installation

1. Remove the engine cover.

2. Remove the Air Cleaner (ACL) assembly. For additional information, refer to Fuel Delivery and Air Induction.

3. Disconnect the ignition coil electrical connector.

4. NOTE: Use a twisting motion while pulling up on the ignition coil.

Remove the bolt and the ignition coil.

- To install, tighten to 6 Nm (53 lb-in).

5. NOTE: Verify that the ignition coil spring is correctly located inside the ignition coil boot and that there is no damage to the tip of the boot.

To install, reverse the removal procedure.

- Apply dielectric compound to the inside of the coil boots.